Directed Audio 300/2 - Manual (Page 13)

13
© 2003 Directed Electronics, Inc
SPECIFICATIONS
Directed model 200/2 300/2 250/4
RMS continuous power per channel, both chan-
nels driven into 4 ohms from 20 to 20,000 Hz,
with less than 0.08% Total Harmonic Distortion
@ 14.4 VDC
RMS continuous power per channel, both chan-
nels driven into 2 ohms from 20 to 20,000 Hz,
with less than 0.1% Total Harmonic Distortion @
14.4 VDC
RMS continuous power bridged into a 4 ohm
load from 20 to 20,000 Hz, with less than 0.1%
Total Harmonic Distortion @ 14.4 VDC
Dynamic power rating (IHF-202 Standard)
bridged into 4 ohms 50 watts 7755 watts 3355 watts
xx22 xx22 xx44
7755 watts 112255 watts 5500 watts
xx22 xx22 xx44
115500 watts 225500 watts 110000 watts
xx11 xx11 xx22
220000 watts 330000 watts 225500 watts
Signal-to-Noise Ratio Greater than 95 dB
Frequency Response 20-20,000 Hz ± 0.5 dB
Damping Factor @ 4 ohm Greater than 200
Crossover Switchable high or low pass
12 dB/octave
Bass Equalization +8 dB, centered at 40Hz
Input Impedance 20K ohms
Input Sensitivity Variable from 150 mV to 8 volt
Output Impedance 2 to 8 ohms, stereo
4 to 8 ohms, bridged
Supply Voltage 10 to 16 VDC
Fusing and Power 20A 25A 25A
Minimum Cable Requirements (AWG) #12 #10 #10
(Per amp, trunk mounted)