REMKO ATR-3 - Manual (Page 10)

10
Setting the Parameters
When you press the PROG programming button
for 3 seconds, you are taken to a menu where the
various control parameters can be set. The values
to be set are not required for controlling the
REMKO ceiling fans. If you end up at this menu
by mistake, press the buttons below to exit the menu.
Display Button Explanation
1. Display PROG Press for 3 seconds = Parameter setting
2. diFH 1.0 SET Confirm entry
3. AnLo 0 SET Confirm entry
4. AnHi 100 SET Confirm entry and end programming
Programming instruction
For the authorised electrical installation personnel!
•
Before mounting the temperature control, determine the following:
1. Number and mounting locations for the ceiling fans
2. Position of the sensors
3. Mounting location of the control unit
4. Dimensions and placement of power and control lines
•
Follow the mounting and operating instructions for the ceiling fans. To-
tal power supply max. 6.3 A.
•
Connection and service may only be performed by authorised electri-
cal personnel.
•
Prior to performing any work on the unit, all power lines must be free
of electrical current and secured against switching on again.
•
The connections for power lines, ceiling fans, temperature sensors
and any control lines for controlling a heater must be made in accor-
dance with the wiring diagram on page 14.
•
The unit made only be connected to lines that are permanently at-
tached in closed, dry rooms.
Installation Instructions