Dialogic Mitel SX-2000 - Manual (Page 18)

Mitel SX-2000 Lightware
18
6. PBX Setup Notes
6.1 Mitel SX-2000 Lightware
This section provides information about the Dialogic
®
4000 Media Gateway Series PBX administration
requirements for Mitel SX-2000 Light systems. This information includes:
1. T1 Interface Administration
2. Configure the Mitel SX-2000 Light for the T1 Q.SIG protocol
3. Program Automatic Route Selection
4. Configure T1 protocol on NSU
Note: This document was developed using the Mitel SX-2000 Light system with the following software versions
and MOSS Options:
1. SX-2000 Lightware Version 34.2.0.20
2. IMAT Version 7.5.1.4
3. MOSS Sheet Options:
Description Option Number
Message Center 31
MSAN/APNSS 37
MSDN/DPNSS Data
38
MSDN/DPNSS Public Net Access 39
MSDN/DPNSS Voice I 41
MSDN/DPNSS Voice II 42
MSDN/DPNSS Voice III 43
MSDN/DPNSS Voice IV 44
MSDN/DPNSS Voice V 45
MSDN/DPNSS Voice VI 46
QSIG 57
T1/D4 64
Notes:
•
Other software versions may not support certain features specified in this section.
•
The terms “Select” and “Set” are used to imply the respective actions of using the arrow keys to highlight the
specified choice and of typing in the specified value.
•
The installation of the T1 board must be validated prior to this configuration. Sometimes this can only be
done by the switch vendor depending on the administration access capability.