Dimplex DFG2562SS - Manual (Page 7)

7
Site Selection and
Preparation
! NOTE 1: A 15 Amp, 120 volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNINg: Ensure the
power cord is not installed so
that it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
①
select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
high traffic.
②
For ease of electrical hook
up you may wish to locate the
Installation
fireplace near an existing outlet
(refer to noTE 1) for plug-in
convenience.
If installing a new outlet for this
electric fireplace:
Construction and electrical •
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
•
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed
electrician.
The dimensions of the firebox are
26 inches (660.5 mm) wide X
18 ⅞ inches (479.5 mm) high
X 8 ¾ inches (223 mm) deep.
The firebox does not require any
additional venting.
For all installation options, ensure
that the fireplace opening has the
following MINIMUM dimensions
(Figure 1):