Draytek 2900 - Manual (Page 11)

Vigor2900 Series User’s Guide 5
1 1 . . 1 1 . . 4 4 F F r r o o n n t t a a n n d d R R e e a a r r V V i i e e w w f f o o r r V V i i g g o o r r 2 2 9 9 0 0 0 0 i i
ACT ISDN QoS Attack VPN Printer WAN P1 P2 P3 P4
LAN
LED Status Explanation
ACT (Activity) Blinking The router is powered on and running properly.
On The ISDN network is correctly setup. ISDN
Blinking A successful remote connection on the ISDN BRI
B1/B2 channel.
QoS On The QoS function is active.
On DoS Defense function is active. Attack
Blinking An attack is detected.
VPN On The VPN tunnel is launched.
Printer On The USB interface printer is ready.
Orange A normal 10Mbps WAN link is ready.
Green A normal 100Mbps WAN link is ready.
WAN
Blinking Ethernet packets are transmitting.
Orange A normal 10Mbps connection is through its
corresponding port.
Green A normal 100Mbps connection is through its
corresponding port.
LAN (1, 2, 3, 4)
Blinking Ethernet packets are transmitting.
Factory
Reset
WAN P1 P2 P3 P4 PWR Printer ISDN
Interface Description
Printer Connecter for a USB printer.
PWR Connecter for a power adapter.
0/1 Power Switch.
P1 – P4 Connecter for local networked devices.
WAN Connecter for remote networked devices.
ISDN Connect for NT1 (or NT1+) box provided by ISDN service provider.
Factory Reset Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and
keep for more than 5 seconds. When you see the ACT LED begins to
blink rapidly than usual, release the button. Then the router will restart
with the factory default configuration.