Scotsman HD150 - Manual (Page 3)

Installation: General
After the carton has been removed from the
dispenser, the legs may be installed.
Place flat portions of the carton on the floor behind
the dispenser and lay the dispenser down on its
back.
Thread the legs into the base of the dispenser. Be
sure that the legs are screwed in all the way. Turn
the leg levelers in all the way.
Move the dispenser to an upright position and set
it in the location where it will be installed. Note
where drain lines and electrical connections will be
made.
Drain:
The dispenser has a 3/4" FPT drain fitting at the
bottom center of the back panel. Connect 3/4" rigid
tubing to this connection, a vent is recommended
for most installations. Route the drain tubing to the
building drain. Follow all applicable plumbing
codes.
Because the drain tubing will be very cold,
insulation is recommenced.
Electrical:
There is an electrical junction box on the lower
back panel
Make the electrical connections there. Follow all
applicable electrical codes. Use a licensed
electrician.
The dispenser must be installed so that it is a
separate piece of equipment from the ice machine.
The drains and electrical supply must be separate.
Note
Remove any packing material from inside the
storage bin. Retain keys for later use.
Check that gasket tape is on the top outside edge of
the dispenser where the ice machine will rest.
Drain
HD150
May 2000
Page 3