Delta 31-750 - Manual (Page 6)

6
Fig. 4
Fig. 5
Fig. 7
Fig. 6
H O O K A N D L O O P
If you are using the hook and loop backed abrasive disc,
simply position hook and loop abrasive disc (A) Fig. 4,
directly onto disc plate pad (B).
ASSEMBLING ABRASIVE
DISCS TO DISC PLATE
IMPORTA N T:M A K E C E R TAIN T H E M A C H I N E IS DIS-
C O N N E C T E D F R O M T H E P O W E R SOURCE.
There are two types of 9 abrasive discs available for
the sander: hook and loop, and adhesive-backed abra-
sive discs.
P R E S S U R E SENSITIVE ADHESIVE (PSA)
1. IMPORTA N T:If you are using the pressure sensitive
adhesive-backed abrasive disc, you must first apply tran-
sition pad (C) Fig. 5, to disc plate pad (B).
2. Remove backing (D) Fig. 6, from abrasive disc (E)
and press the disc onto transition pad (C).
ADJUSTING TA B L E
IMPORTA N T:Before operating the sander, the table
surface must be positioned so it is slightly lower than the
sanding disc.
1. Place a straight edge (A) Fig. 7, on abrasive disc (B)
and check to see if the disc is slightly higher than the
table surface (C). NOTE: Check the table height directly
over two adjustment screws (D) Fig. 7, and again over
screws (E).
A
B
B
C
C
E
D
A
E
D
E
B
C
D