Delta Electronics DTE Accessory DTE-20T - Manual

DTE Accessory
Instruction Sheet
Thank you very much for choosing DTE-20T. Please read this instruction sheet before using your DTE-20T to ensure proper
operation. Keep this instruction sheet handy for quick reference.
Warning
1. Please hold the plastic terminal when installing DTE-20T to prevent electrostatic discharge (ESD).
2. Prevent dust or metallic debris from falling into the device and cause malfunction. DO NOT modify or uninstall DTE-20T
without being permitted. DO NOT use empty terminals.
3. When installing DTE-20T, please make sure the power of DTE main unit is switched off and insert DTE-20T into the correct
slot on DTE main unit.
4. Make sure you install DTE-20T correctly before switching on the power; otherwise serious damage may occur.
5.
DO NOT touch the terminals or repair the device when the power is on; otherwise an electric shock may occur.
Functions & Electrical Specifications
Power consumption Max. 0.5W
Input sensor 4 channels of thermocouple: K, J, T, E, N, R, S, B, L, U, TXK
Sampling cycle Thermocouple: 1.0 second (4 channels)
Terminal connection Can only be inserted into INB slot on DTE10T main unit
The sensor slot (INA/INB) only accepts the same input type. For example, if you select DTE-20T as accessory, you can only
use it on DTE-10T main unit.
How to Install
1 Remove all the terminal
blocks on the panel.
2 Uncover the panel. Make
sure which slot is the
correct one and insert
DTE-20T into the slot.
3 Cover up the panel. 4 Insert the terminal blocks
back
The content of this instruction sheet may be revised without prior notice. Please consult our distributors or
download the most updated version at http://www.delta.com.tw/industrialautomation