Smart Avi HDR 8X8 LP - Manual (Page 12)

USING RS-232 CONTROL (THIRD-PARTY SOFTWARE)
How to properly create an RS-232 connection between a PC and
HDR8x8LP.
Establish a connection to HDR8X8LP:
1. Connect a straight through male-to- female RS-232 cable (not in-
cluded) to the RS-232 connector on the PC.
2. Connect the other end of the cable to the RS-232 port of the
HDR8x8LP
3. Power on the device.
Setting up the Terminal Application:
1. Open Hyperterminal on the PC.
(or use the terminal client of
your choice)
2. Use the default settings to
create a connection to the
device: 9600
9600 9600 9600, 8 8 8 8, N N N N, 1 1 1 1.(see set-
tings on right).
3. Be sure that Flow Control is
None.
4. The output of the device will be
the same as the PC.
For more information about the RS-232 Command Protocol, visit
www.smartavi.com.