Smithco Sand Star I 45-001 Parts & Service Manual - Manual (Page 152)

C-81
Rear Attachment
43-170 RAHN GROOMER
SMITHCO QUICK ATTACH MOUNTING INSTRUCTIONS
1. INSTALL RAHN CENTER LIFT ASSEMBLY INTO THE SMITHCO QUICK ATTACH MOUNTING SLOT
UNTIL IT ENGAGES WITH THE SPRING ASSISTED STOP. MAKE SURE THE 3/4” RODS ARE BELOW THE
QUICK ATTACH CROSS MEMBER. (PICTURE #1)
2. INSTALL THE RAHN PULL ARM BRACKETS (LEFT & RIGHT) ON TOP OF THE BRACKETS USED
FOR THE QUICK ATTACH SYSTEM USING THE HARDWARE PROVIDED. WHEN INSTALLING THE BRACK-
ETS, THE BOLT HOLES ARE LOCATED TOWARD THE WHEELS AND THE EARS OF THE BRACKET ARE
TO THE INSIDE.
3. REMOVE CLEVIS PIN IN THE ROD END OF THE CYLINDER. INSTALL CYLINDER MOUNT EX-
TENDER OVER EXISTING EAR ON CROSS MEMBER. TIGHTEN BOLT AND REPLACE PIN. (PICTURE #2)