Smithy Midas 1220 XL - Manual (Page 25)

Figure 6.5 To check bench and bed level accuracies, successively place level at A, B, C, D
(longitudinal positions) and E and F (transverse position). Bedways alignment in the
longitudinal plane should be better than 0.0016/40” ; alignment in the transverse
plane should be better than 0.0024/40”.
Selecting a Location
There are several major considerations when selecting a location for your Smithy:
1.
Operation is from the apron side, so allow at least 40 – 48” clearance in front of the
machine.
2.
The machine should be on a 30amp circuit and close to the power outlet. If you must
use an extension cord, check with an electrician to make sure the cable can handle the
electrical load.
3.
Provide ample working light over the operator's shoulder.
4.
Place the machine on a solid foundation-concrete, if possible. If the floor is wood, make
sure it can support the machine and workbench. Brace it if necessary to prevent sagging
or settling.
5.
Make allowances at the back of the machine tool, at the end, and above it for later
additions, attachments, and/or accessories. Provide clearance on the left end for bar
stock to be fed through the spindle. If you are considering placing more than one machine
in an area, allow enough floor space to feed long bar stock to each machine.
Cleaning and Lubricating the Machine
Smithy machines are shipped with a protective grease coating. To remove it, spray on
WD-40, let it sit for a few minutes, and wipe it off with rags. Use a brush and
noncorrosive kerosene or white mineral spirits to clean hard to reach places.
Give special attention to the leadscrew. Use a brush or cotton string to clean down into
the threads.
The best way to clean the powerfeed gears is to remove them completely. wipe the
pulleys with a damp rag.
6-4 Or Visit www.smithy.com
Uncrating and Setting Up the MI-1220 XL