SOLAC CP7381 - Manual (Page 10)

9
RECOMMENDATIONS
• Do not insert the blade of the round head (2) more than 0.5
cm into the ear or the nose, since it could damage the tym-
panum or the membrane of the nose.
• Make sure the head (2 or 3) is correctly adjusted to the base.
OPERATION:
• This model works with an AA battery. To fit the battery, turn
the protective battery cover Fig. 1(8) to the left until the ▼
symbol is in line with the ▲, and pull on the cover. Fig. 2 Fit
the battery in the appropriate place with the negative termi-
nal (-) pointing to the head. Fig. 3.
• Put the bottom cover back in position Fig. 1(8), ensuring that
the ▼ symbol is in line with the ▲ symbol, and turn it until
it is in line with the • symbol. Fig. 4
• When you turn it on Fig. 1(4), the light comes on Fig. 1(5),
to help you locate the hair.
To trim ear hair:
• Use the round head Fig. 1(2)
• Turn on the appliance and insert it in the exterior of the ear.
Fig. 5
• Carefully move the trimmer around the area with hair.
To trim nose hair:
• Use the round head Fig. 1(2)
• Turn on the appliance and insert it in the nose (do not insert
it more than 0.5 cm). Fig. 6
• Remove the nose hair by moving the appliance in small circles.
To set the type of cuts (beard, sideburns, neck hair, etc.):
• Turn the appliance off.
• Turn the round blade head Fig. 1(2) to the right and remove
it from the head base Fig. 1(1).
• Fit the flat blade head Fig. 1 (3), adjusting it to the guide and
turn it to the left until it is correctly in place.
• Slide the blade along the desired cutting line without press-
ing on the skin to avoid cuts. Fig. 7
• Use the guide comb (10) to adjust the trimmed hair length.
Place it on the flat blade and select the cutting level desired.
The first time, we recommend that you start with the maxi-
mum length and gradually reduce it until you achieve the
desired effect.
Depilador CP7381.indd 9 18/11/10 13:23