SOMFY SUNIS INDOOR WIREFREE RTS SUN SENSOR - Manual

Programming/Operating/Installation Instructions
™ Sunis WireFree RTS Light Sensor
The Sunis RTS Light Sensor is a wireless radio transmitter compatible with RTS motors and externally mounted RTS receivers.
Window or Sill mounted, the Sunis RTS operates motorized window coverings in accordance to the amount of sunlight received.
Sunlight sensitivity (threshold) can be adjusted for varying degrees of sunlight intensity.
Commands are transmitted by radio waves at 433.42 MHZ
Power: 3V Lithium battery, CR2430
Operating temperature: 0 deg. C/32 deg. F - +60 deg. C/140 deg. F
Range: Up to 65ft.
Mount: Window glass/sill
Dimensions: Diameter 2 3/16” /(55.5mm) x Depth 3/4” /(19mm)
Indoor Use Only
1. Using a Paperclip or similar device, press and hold the program button (3 sec.)
on the previously addressed Sunis Light Sensor or Telis Transmitter. (See Figure 1)
The RTS receiver or motor will confirm programming mode in their respective
manners.
2. Using a paperclip or similar device, briefly press the programming button (1 sec. max)
located on the Sunis Light Sensor (See Figure 1.) The RTS receiver or Motor will confirm
the deletion of the Sunis Light Sensor in their respective manners.
ADDING A SUNIS WIREFREE RTS LIGHT SENSOR- INITIAL INSTALLATION ™
1. Carefully remove rear cover to expose sensor control setting panel.
2. Set the RTS Receiver or Motor into Programming Mode (Refer to the
installation instructions of the relevant RTS receiver or motor for this
procedure).
3. Slide the ON/OFF selector switch to the ON or Position
4. Using a paperclip or similar device, briefly press the programming button
(1 second max) located onthe Sunis light sensor. (See Figure 1) The RTS
receiver or Motor will confirm the addition of the new Sunis light sensor in
their respective manners.
DELETING A SUNIS WIREFREE RTS LIGHT SENSOR FROM MEMORY ™
# 9013707
On/Off Selector Switch
Control
Setting Panel
Program Button
Rear Cover
STEP ONE PROGRAMMING
Note: Repeat steps 1-3 when multiple motors are required to operate from the
Sunis light sensor
TI N B Y
DESCRIPTION
FIGURE 1
Note: During initial programming, provide power only to motor or RTS
receiver being programmed.