SoundFreaq SFQ-05 - Manual (Page 15)

3. Tap the button repeatedly to select the
AUX IN mode.
4. Start playback on the external device.
.14.
1. Select FM tuner mode with the button.
2. Switch to the frequency display if the display
is channel number.
3. Tune a desired frequency. You can use either
of the below methods to tune the frequency.
Presetting a Station
System Display
System Display
System Display
System Display
System Display
4. Hold the SET button to start storing a
station.
• The channel number starts blinking.
5. Use the / buttons on the System to
select the channel number (from 01 to 20) to
be set.
6. Press the SET button again to store the
frequency. The selected frequency will then
be stored with the preset channel number.
• The display will be switched automatically to
clock show display after a few seconds.
A. Manual Tuning - Briefly tap " "/ " "
button repeatedly to move frequency to
frequency (from 87.5 MHz to 108.0 MHz) until
you find the desired station.
B. Auto Scanning - Hold " "/ " " button
until the frequency display starts blinking.
The frequency will be scanned automatically
until a station is found.
External Device
You can enjoy the sound from an optional
component such as a digital music player
through the speakers of this unit. Be sure to
turn off the power of each component before
making any connections. For details, refer to the
instruction manual of the component to be
connected.
Connect an external device to the AUX IN jack
on the back panel of the System using a stereo
audio cable.
1. Tap any button to turn on the System.
2. Set the volume to the minimum.
To audio output such as
CD/MD/digital music
player, etc.