Spohn 923T-SEL User Manual
Page 5
SPHERICAL REAR SWAY BAR END LINK INSTRUCTIONS
1. Bolt both of the u-shaped clevises to the rear upper end link chassis mounts using
the supplied 5/8” steel top lock nuts. Use an adjustable wrench to hold the clevis at
its properly clocked orientation and a 15/16” socket on the lock nut and fully tighten
the nuts. See Picture 1 below.
2. Loosely connect the other end of both rear sway bar end links to the rear sway
bar. Remove the Nylock® nut from the bottom of the end links and then sandwich
the sway bar between the two bushings (same as the factory end link). Then re-
install the 3/8” Nylock® nut and make it snug using a 9/16” wrench, but not fully
tightened. See Picture 1 below.
3. Safely lower the vehicle to the ground.
4. With the vehicle on the ground and the suspension loaded, using a 9/16” wrench,
tighten the 3/8” Nylock® nut on the bottom of both of the end links. Tighten the
nuts until you see the bushings starting to deform, then STOP.
5. Installation is complete.
Picture 1
2