Reprogramming a single homelink button, Security – Dodge 2005 Durango User Manual

Page 148

Advertising
background image

Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:

1. Press and hold the desired HomeLink button. Do
NOT

release the button.

2. The indicator light will begin to flash after 20 seconds.
Without releasing the HomeLink button, proceed with

ЉProgrammingЉ step 2

For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515

.

Security

Garage Door Opener Operation with Security
Alarm (if equipped)
If your vehicle is equipped with the Security Alarm
feature, the operation of the HomeLink feature will be
purposely inhibited if the Security Alarm is

ЉArmedЉ.

This prevents HomeLink operation due to un-authorized

vehicle entry. HomeLink operation will be re-stored
when the Security Alarm has been

ЉDisarmedЉ.

If you sell your vehicle, be sure to erase the frequencies.

To erase all of the previously trained frequencies, hold
down both outside buttons until the 2 dots below House
Symbol begin to flash (about 20 seconds).

This device complies with part 15 of FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:

• This device may not cause harmful interference.
• This device must accept any interference that may be

received including interference that may cause undes-
ired operation.

NOTE:

Changes or modifications not expressly ap-

proved by the party responsible for compliance could
void the user’s authority to operate the equipment.

148

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising
This manual is related to the following products: