Super Systems 3 Series - Manual (Page 44)

Operations Manual Series 3
44
10.2 Example: To Set Ramp Rate
This is available in Level 3.
Do This The Display You Should
See
Additional Notes
1. Press  as many times as necessary to
select ‘SETPOINT LIST’
2. Press as many times as necessary to
scroll to ‘ S P 1 ’
3. Press  or  to adjust setpoint 1
This step can be repeated for the lower setpoint limit
‘SP.LO’
4. Press to scroll to ‘S P 2 ’
5. Press  or  to adjust setpoint 2
6. Press as many times as necessary to
scroll to ‘S P . R A T ’
7. Press  or  to set the rate at
which you require the setpoint to change
Whenever the setpoint is changed, the controller will ramp
from its current setpoint to the new value at the rate set in
units per second, minute or hours as set by the ‘RAMPU’
parameter.
It will also change at the same rate when switching
between SP2 and SP1 (but not between SP1 and SP2)
The setpoint rate resolution is generally one decimal point
more than setpoint/PV resolution
73.00
s p 1
50.00
s p 2
6.000
S p . r at