SWEDX Blade User Manual
Page 7
Design and specifications are subject to change without notice.
Remote Control Notice
The remote control included is based on 2.4 GHz
and infrared. To swtich between 2.4 GHz and
infrared do the following:
Press and hold
for 5 seconds. The
red LED lamp will flash and alter the current
mode. When pressing any key on the remote
control the correspondent LED lamp will lit. When
the LED lamp is red then the remote is in 2.4
GHz mode. When the LED limp is blue then the
remote is in Infrared mode.
Recent screens models from SWEDX are all
based on 2.4 GHz while older screen models are
based on Infrared. This remote control is
compatible with both models.
When the remote is in 2.4 GHz mode it can be
used without targeting the screen since the
receiver is built in. Each screen has a pre-
configured remote control meaning that if you
have several screens the remote control will not
function on each other.
If for some reason you need to re-program the
remote with the screen (in this case the Blade) do
the following
1. Connect the screen (in this case the Blade) to
power outlet
2. Press
buttons on the remote control
simultn
eously for about 5 seconds.
The RED lamp on the top edge of the remote will
flash indicating that the remote is programmed
with the particular screen.
OK
G
P
E
FA
V
OK
9
CH
VOL
ARC AUDIO SUB. TV/RADIO
HDMI
USB
AV
TV
. LI
H
ST
C
7