Q-See QSDL503AD - Manual (Page 7)

QSDL503AD USER MANUAL
5 | P a g e
Section 5: SETTING UP THE MAIN CONTROL PANEL
After loading the batteries in the Wireless Indoor Lighted Siren, Infrared Sensors and Magnetic
Window/Door Sensors, you are now ready to configure the Main Control Panel. Turning the Main
Control Panel ON will generate the message NO-SAVE in the Display Panel. This means that your
system has no information stored and must be configured in order to operate. To set your system up
correctly, you will need to do the following:
1. Record an Outgoing Message into your System: Your alarm system will call you in the event of a
security breach with a pre-recorded outgoing message. Press the REC button on the front of your
Main Control Unit (See Picture 7) in order to begin recording your outgoing message. Once you press
the REC button, the system will respond by displaying a message that says REC in the Display
Screen (Picture 7). Once this message is displayed, you can begin recording a 10 second message.
You will hear an audible beep when you have reached the allotted 10 seconds. You have now set up
the outgoing message that will be played when your system auto dials the telephone numbers you
need to configure in step 2.
2. Program up to 6 Telephone Numbers into your System: Your alarm system will call you in the
event of a security breach with a pre-recorded outgoing message. To program the telephone numbers
your system will automatically dial, press the following keys on the front your Main Control Unit
(Picture 7):
 + 1 + 10 Digit Telephone Number + #
Use the same sequence of keys above to program up to 6 telephone numbers. For each number you
successfully store, your system will respond by displaying a Serial Number in the Display Screen that
corresponds to the order of entry (the first number you store will generate the Serial Number 1, the
second will display the Serial Number 2, the third will display the Serial Number 3, and so on). The
order in which your system dials out in the event of a security breach correlates to the Serial Number.
To erase the telephone numbers saved into your system, press the

+
#
keys on the front of your
Main Control Unit (Picture 7). You will hear an audible beep informing you that you have successfully
erased the numbers stored in your system.
(Picture 7)
Display Screen
Microphone
Indicator Light
Record
Code
Lock Keypad
Panic (Alarm)