Tri Tool 212B Flange Facer - Manual (Page 9)

9
Model 212B-FF Flange Facer
92-0291 : Rev. 921230
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU or lighter) or oil which is
specified for the air motor.
If the Model 212B BEVELMASTER TM with the Model 212B-FF Flange Facer is
operated in the vertical position (cutting head up), the chips and/or other debris
should be removed after each pass has been completed.
Clean Up
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operation are
removed.
DAILY MAINTENANCE
Visually inspect all parts for damage due to chips, impact or improper use.
Repair or replace broken or damaged parts as necessary.
Wipe the machine clean of cutting fluids, dirt and grime and then coat it with a light
film of oil
.