Tri Tool 212B Single Point Hydraulic Motor Assembly - Manual (Page 7)

7
Model 212B SP Hydraulic Motor Assembly
92-0762 : Rev. 010206
Problem: There is a loss of air power
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
Problem: There is a loss of hydraulic power
The hydraulic supply pressure is too low.
The hydraulic filter is plugged.
The hydraulic line size is insufficient.
The hydraulic line is too long.
Problem: The tool bit will not reach the work
Incorrect tool blocks are installed for the size of the pipe or tube being worked
on.
Incorrect tool bit is installed.
Problem: The hydraulic motor will not start
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.