Tri Tool 212B Single Point Flange Facer Miter Mandrel - Manual (Page 20)

20
TRI TOOL INC.
92-0738 : Rev. 980331
DISASSEMBLY AND ASSEMBLY
Disassembly of the Miter Mandrel Head
Back off the four (4) Parallel Offset Adjusting Screws about three full turns each.
Unscrew the draw rod and slide the Mandrel Shaft Assembly rearward.
Remove the Draw Nut, the Adapter Plate Assembly and the Torque Plate.
Remove the four (4) Angular Offset Adjustment Screws and the four (4) Spherical
Washers.
Remove the Gimbal Plate.
Remove the Jackscrews and Spacers from the Head Assembly.
Assembly of the Miter Mandrel Head
Assembly is done in the reverse order of disassembling.
NOTE: Read the Maintenance section prior to assembling the Miter Mandrel
Head.