Tri Tool 648RBL Clamshell - Manual (Page 22)

22
TRI TOOL INC.
92-1238 : Rev. 070126
CAUTION:
The Feed Pin must strike the Sprocket on the edge of the Tooth.
Reference the previous two images, 'Correct Alignment of the Feed Pin' and
'Feed Pin Positioning'.
When the Feed Pin to Sprocket engagement is not as shown in the
referenced images, operation of the Clamshell may cause serious damage or
destroy the Feed Pin and/or the Sprocket.
When the Feed Pin to Sprocket engagement is as shown above, then it will be
necessary to loosen the four (4) Cap Screws on the Tripper Bracket, so that it may
be adjusted to the proper gap, .020” (.51 mm) to .030” (.76 mm), required for proper
engagement.
SELECT AND INSTALL THE DESIRED TOOL BIT SET
Tool Bit Set-Up
Select the proper Tool Bit set. See "Tool Bit' section of this manual.
Incorrect Alignment of the Feed Pin
Tripper Block Adjustment