DCS Flat Panel TV User Manual

Page 8

Advertising
background image

Set PA-4260 width

The PA-4260 is capable of handling a wide range of landed insert

widths. Measure the horizontal distance between mounting lands

on your display, and set the width of the Mounting Rails as shown,

Standard Range: 38 1/2”(98 cm) to 15 3/4”(40 cm)

Standard Configuration

For standard range configurations, loosen the screws on the sliders

using the supplied Hex Wrench; adjust rails to desired width, and

then re-tighten screws.

Narrow Range: 15 1/2”(39 cm) to 3 1/2”(9 cm)

Narrow Configuration

For narrow range configurations, flip slider/rail assembly over (as

shown below) before inserting them into the channels.

Secure Sliders and back plate

Secure sliders with (8) button head screws. For medium and narrow displays, where the nuts on the

slider are beneath the back plate, thread button head screws through the back plate and into the slider

as shown.

Note: The outer corners of the back plate must always be secured with a screw. For wide displays,

where the nuts on the slider are positioned outside of the back plate, use Nylon jam nuts with button

head screws (supplied) to secure the back plate, as shown.

Advertising