Triplett TVR10/100/1000 - Manual (Page 7)

TVR10/100/1000 ("TVR1000") List of Functions
The TVR1000 performs the following functions:
10/100/1000 BASE-T LAN Tests: The TVR1000 plugs into active
hubs, switches and PCs to verify 10, 100 and 1000 Base-T operation.
Only the Main Unit is required for these tests.
● Verifies if a LAN device (hub, switch, PC) is ON, its speeds and
duplex capability and if it is wired as a hub, switch or PC.
● Verifies the negotiated speed and duplex between any two
LAN devices (Inline mode).
● Detects the presence of Power over Ethernet (PoE) and indicates
whether it is endspan or midspan.
● Checks if straight thru or crossover patch cable is required.
● Finds speed bottlenecks on 10, 100 and 1000 Base-T LANs.
● On-line monitors LAN link (between two devices). Inline mode.
Cable Testing and toning: The following tests are performed by the
TVR1000 Main Unit and Remote Probe (except where indicated).
● Locates miswired cables.
● Locates missing cables.
● Locates cables that can not support 100Base-T4 and 1000
Base-T operation (for LANs that require 4 pair wiring).*
● Tests connection to hub (pairs connected to hub).*
● Tests connection to PC (pairs connected to hub).*
● Tests installed cables (pairs wired and type).
● Tests patch cables (pairs wired and type).
● Remote Probe helps locate and trace inactive cables.
● Remote Probe traces active cables connected to hubs
and PC without interfering with LAN performance.
* Test performed by the Main Unit only (does not require the
use of the Remote Probe).
5