Triplett Fox & Hound 3 – PN: 3397 - Manual (Page 15)

15
tery to be fully inserted. The finger tab on the Strap should
be sticking out of the Battery Compartment. This tab is used
to remove the battery. Fold the tab over, and secure the Bat-
tery Cover to the case by inserting the end near the Ear-
phone Jack (GG) first, and snapping the opposite end of the
Cover to the case.
7.2.2: Testing the battery in the HOUND 3
The battery in the HOUND 3 will not last as long as the bat-
tery in the FOX. The LED Lights (CC) can be used as a rough
indication of battery charge. With a fresh battery, the Lights
will be bright, and the HOUND 3’s Speaker (LL) will produce
a loud, strong, signal from the FOX. As the battery is drained,
the signal from the FOX will not sound as loud in the HOUND
3’s Speaker. When the Lights begin to dim, the battery should
be replaced.
7.3: A Few Basic Tests
Turn on the FOX by sliding the Function Switch to the TONE
position. Set Tone Switch (C) to the WARBLE position. This
is the position that most users prefer for wire location and
tracing.
Rotate the HOUND’s Sensitivity Control (FF) to its mid-posi-
tion. Turn on HOUND 3 by pressing and holding the Power
Button (EE). Bring the HOUND 3’s probe (AA or BB) near the
FOX’s alligator clips. The warbling signal from the FOX should
be heard in the HOUND 3’s Speaker (LL). Adjust the Sensi-
tivity Control for the desired loudness. Move the probe of
the HOUND 3 closer to and farther away from the FOX’s alli-