VAUDE Mark L 3P - Manual (Page 18)

11
ENGLISH
only: Insert the pole ends into the sockets at the in-
ner tent foot and tension the pole. Starting in the
middle, attach the inner tent to the pole using the
toggle and ring.
5. Hang the tent skin on the front and rear pole
connectors using ridge hooks (D), then push into
the relevant metal sockets at front and back (E).
6. Starting from the middle place the cords over the
ridge pole and hook over the loop below. Then,
moving from above to below, proceed to do the
same with the other poles (E).
7. Anchor the porch and, if necessary, use guy ropes.
Please note: It is best to wrap the webbings of the
guy ropes around the poles (f).
8. Ensure that there is sufficient ventilation. The porch
is ideal for individual adjustments.
TakE DOWn – gEnEraL inSTrUCTiOnS:
• Remove everything from the tent’s interior.
• Freestanding tents can be gently shaken out to
remove leaves, sand, and other debris.
• Turn the tent over with floor facing upward and
allow it to dry a bit longer.
• If it’s not possible to dry the tent completely before
packing it, this should be done within 12 hours to
prevent the risk of mold and mildew growth.
• As in the tent set up, never pull the poles out of the
pole sleeves; rather push them through.
• When storing a tent in its stuff sack, make sure that
stakes and poles don’t press against the tent fabric
and damage it.
• Before taking down your tent, close all zips and
roll up the guy lines. That way you won’t have to
untangle them when it comes time to set the tent
up again, and pitching is that much easier.
DiSManTLing – “MODEL­SPECifiC”:
1. Pull out the tent pegs.
2. Unhook the ropes.
3. Remove first the ridge pole and then the other poles.
4. Fold up the poles and roll them up with the tent,
if possible. Do not force the poles into the storage
bag if it is full as this may cause damage to the
storage bag and tent.