VAUDE Hogan SUL XP 2P - Manual (Page 18)

11
ENGLISH
the foot area) using buckles and insert into the feet
(E).
8. Secure the tent to the ground with tent pegs and
anchor the porches (if needed, use guy ropes).
9. Ensure there is adequate airflow. This can be regu-
lated in a rainproof manner via the zip in the porch.
TaKE DoWn – gEnEraL inSTrUCTionS:
• Remove everything from the tent’s interior.
• Freestanding tents can be gently shaken out to
remove leaves, sand, and other debris.
• Turn the tent over with floor facing upward and
allow it to dry a bit longer.
• If it’s not possible to dry the tent completely before
packing it, this should be done within 12 hours to
prevent the risk of mold and mildew growth.
• As in the tent set up, never pull the poles out of the
pole sleeves; rather push them through.
• When storing a tent in its stuff sack, make sure that
stakes and poles don’t press against the tent fabric
and damage it.
• Before taking down your tent, close all zips and
roll up the guy lines. That way you won’t have to
untangle them when it comes time to set the tent
up again, and pitching is that much easier.
DiSManTLing – “MoDEL­SpECifiC”:
1. Slacken the pegs and outer tent and take down the
inner tent.
2. Clean the pegs of dirt and store in the peg bag, lay
out the poles and store in the pole bag.
3. Fold up the outer tent. Spread out the inner tent,
fold in to 1/3 the width and press down. Lay the
outer tent and the two bags onto it and roll up the
tent.
4. Put the tent into the bag. Do not push the poles into
the full bag afterwards, otherwise the bag and tent
may be damaged.
SToragE/CarE/rEpairS:
• As soon as the tent is dry and clean it can be stored
in its pack sack in a well-ventilated, cool and dry
place. Please do not store the tent near paints, ad-
hesives, oils, plastics, or fuels (gas canisters, etc.)!