Venstar T0051FS Installation - Manual (Page 4)

Installation Instructions - FlatStat Wall Hanger TM
Again, making sure the wall bracket is straight up
and down, secure the bracket to the wall with the
two phillips screws provided.
The screws will go through the wall and steel tabs,
‘clamping’ the wall hanger securely to the wall.
When ready to mount the FlatStat to the wall
hanger, use the two # 6 machine screws
provided.
Mark the wall location using the inside opening of
the wall bracket as a template.
Make sure the rectangle is straight up and down
and there is nothing behind the planned opening
inside the wall before cutting.
Cut through the drywall just outside the outline.
Using your fingers, bend the steel tabs around
to the inside of the wall as shown.
INSTALLING FLATSTAT WALL HANGER
Page 3