Vinpower Digital Xerox Standard - Manual (Page 62)

Xerox Duplicator 62
5. The failure rate is high.
■ Lower the “write speed” and try again. Refer to “How to Select
the Duplication Speed” on page 35.
■ Quality of blank disc may be poor.
■ Quality of your master disc may be poor.
6. Do I need to update my duplicator’s firmware?
■ Unless your system is getting unstable, we strongly suggest not
updating your duplicator’s firmware. Contact our Tech Support if
your system is getting unstable.
7. Cannot boot-up or fails to upgrade firmware.
■ Contact our Tech Support.
8. Why some writers won’t copy.
■ Reset back to default (Troubleshoot item #9).
■ Contact our Tech Support.
9. How do I reset my duplicator back to default?
■ Use up or down arrow button to navigate to the following
screen.
■ Press >> to enter Utility menu and you should see the follow-
ing screen.
■ Use the up or down arrow buttons to navigate to the Load De-
fault menu and press >> to enter. You will see the following
screen.
■ Press >> to confirm and you system will be loaded back to de-
fault. Once the operation is complete, you will see the following
screen.
XEROX 2.14
13. Utility
Utility
1. Disc Info
Load Default
Press OK to Continue