Vinpower Digital Xerox LightScribe Series - Manual (Page 30)

0 Xerox LS Duplicator
Section 2: Selecting the Copy
Source to the Hard Drive.
Note
Ignore this section and proceed to
Section 3 if you have just completed
Section 1: Loading Master Disc content
into the Hard Drive as an image as this
process will automatically switch the
source to the hard drive.
Step 1: Use the up or down arrow button to
navigate to the Select Source menu .
Step 2: Press >> button to enter the Select
Source menu and you shall see a screen
similar to below:
Step 3: Use the up or down button to lo-
cate the Hard Drive and press the >> button
to select it .
Note
If the hard drive has already been pre-
selected as the source, the duplicator
will NOT respond to the >> button.
Please press the << button to go back
to the main menu.
Once the source has been selected, you will
be guided to the Main menu . You should
see the following screen:
Duplicator 2.20
7. Select Source
Drive 0 Port x.x
ASUS DVD-E818A
HARD DRIVE Port x.x
HITACHI HDS721616PL
Duplicator 2.20
7. Select Source