Watson-Marlow Bredel 265 - Manual (Page 48)

MAINTENANCE
48
8.7 Exchanging replacement parts
8.7.1 General
8.7.2 Replacing pressing shoes
1. Jog the motor until the pressing shoe (B) is
positioned in view of the inspection window (A).
2. Isolate the pump from the electrical supply.
3. Place a tray (A) under the drain plug (B) in the
bottom of the pumphead. Remove the drain
plug. Drain as much Bredel Genuine Hose
Lubricant until the level has lowered just below
the inspection window (D). Check that the
sealing ring (C) is not damaged and replace it if
necessary. Position the drain plug and tighten it
firmly.
CAUTION
Items may be heavy. For all weight and
torque adjustments for replacement proce-
dures under this section, please see the
technical information in chapter
11 .
A
B
A
D
B
C