Welltech WellRec 5600 V.1.0 - Manual (Page 9)

Welltech Computer Co., Ltd.
Step 1: After successfully logon to the system, we need to change the
Network configuration. Click Control > Network to setup the Service
Interface parameters as figure 2.2-1.
Figure 2.2-1
Step 2: Enter the deserved IP address, Submask and default gateway or
selected to “Use DHCP”. Apply the change by clicking Apply button as
figure 2.2-2.
Figure 2.2-2
Step 3:
When screen shows “Change network configuration may cause
server disconnected, are you sure?”
click on OK button to changes
IP address as figure 2.2-3.
Figure 2.2-3
Step 4:
When screen shows “After configuration changed, please re-login
system with new IP address and execute Soft-Reset!”
click OK
WellRec 5600 - 9 -