Westermo GD-01 - Manual (Page 8)

8 6196-2211
Maintenance
No maintenance is required, as long as the unit is used within the specified conditions.
Installation
Mounting /Removal
Before mounting or removing the unit:
Prevent damage to internal electronics from electrostatic discharges (ESD)
by discharging your body to a grounding point (e.g. use of wrist strap).
Prevent access to hazardous voltages by disconnecting the unit from AC/DC
mains supply and all others electrical connections.
Mounting
This unit should be mounted on 35 mm DIN rail which is hor-
izontally mounted on a wall or cabinet backplate.
This unit use convention cooling. To avoid obstructions to the
airflow around the unit, use the following spacing rules.
Recommended spacing 25 mm (1.0 inch) above/below and 10
mm (0.4 inches) left/right the unit.
Snap on mounting (figure)
Removal
Press down the black support at the back of the unit
using a screwdriver (figure).
CLICK!
Min
10 mm
!