Westermo Lynx-x10-F2G - Manual (Page 9)

9 6643-2213
Location of interface ports and LED’s
Ethernet connection TX (8 ports)
Position Signale Direction Description
No.1 TD+ In/Out Transmitted/Received data
No. 2 TD– In/Out Transmitted/Received data
No. 3 RD+ In/Out Transmitted/Received data
No. 4 – Not Connected
No. 5 – Not Connected
No. 6 RD– In/Out Transmitted/Received data
No. 7 – Not Connected
No. 8 – Not Connected
Shield Connected to PE
LED Indicators (for details see page 11)
Power connection (for details see page 7 and 10)
SFP transceivers
(for details see page 7 and 8)
I/O connection
(for details see page 8 and 10)
Console port
(for details see page 8)
Cable 1211-2027
Connection to console port
The console port can be used to connect to the CLI
(Command Line Interface).
The following steps needs to be taken
1. Connect the serial diagnostic cable to the console port
(use only Westermo cable 1211-2027).
2. Connect cable to your computer (USB port, if drivers are needed they can be downloaded
from our Web page).
3. Use a terminal emulator and connect with correct speed and format (115200, 8N1)
to the assigned port.
For more information about the CLI, see the WeOS management guide.
Bottom view