Switch settings md-62h, Status signal factory settings, Transmitted power – Westermo MD-64 H User Manual
Page 3
Advertising
3
6070-2001
Status signal disabled implies an active CTS to
the connected equipment.
Switch settings MD-62H
The MD-62H can, through switch settings, be set in to several modes.
To set the switches, open the plastic case by removing the top cover.
Status signal
Factory settings
S1
Disabled
ON
1 2 3 4 5 6 7 8 9
S1
Enabled
ON
1 2 3 4 5 6 7 8 9
S1
ON
1 2 3 4 5 6 7 8 9
S2
ON
1 2 3 4 5
S2
ON
1 2 3 4 5
Switch S1: 2–9 not used
Transmitted power
Low
S2
ON
1 2 3 4 5
High
Switch S2: 1–4 not used
S1:1-9
S2:1-5
Advertising