AEC 1426-i Twin-Shear Granulator - Manual (Page 25)

1426-i Granulator Chapter 5: Maintenance 24 of 37
5-7 Motor Drive Belt Replacement
Use the following procedure to replace the drive belts:
1. Turn off the main power and remove fuses.
2. Remove the right hand guard, bottom side and back base panels to gain access to the
belts and pulley.
3. Turn the adjusting screw on the motor slide base to release all tension from the belts.
4. Remove the belts
5. Install the banded V-belts and proceed to adjust the belt tension as instructed in
Section 5-6 on page 22.
6. Replace base panels and guards.
7. Replace the line fuses and turn main power on.