Reconnect the negative battery cables – Airaid 200-287 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.18.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
9. Congratulations on the successful install of your
new Airaid Intake System!
Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and screws
are tight.
Reconnect the negative battery
cables!
7. A.) Reinstall the Mass Air Flow sensor into the
Airaid Intake Tube using two 8-32x 3/8” button head
screws (#8). Do Not Use The Factory Screws!
B.) Next, reinstall the factory filter minder and grom-
met into the Airaid Intake Tube.
8. The Airaid Premium filter (#1) is a very tight fit in
the CAB. For ease of installation, hold the filter in
your right hand, and guide the bottom of the filter
past the flange of the tube with your left hand inside
of the CAB. It will fit! Tighten the hose clamp.
Next install the weather strip (#5) on top of the CAB,
starting at the fender and working your way towards
the radiator.
A.
B.
WARNING! If your vehicle has a Vehicle Emission Contr ol Infor mation decal affixed to the factor y air -
box, a new replacement label must be obtained and installed in a readily visible position in the engine compart-
ment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check.
Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall not be
affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a paint-
ed surface is recommended.
FILTER IDENTIFICATION
720-472 Airaid Oiled Media
721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.