Filter identification – Airaid 250-261 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.05.20.14
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter is
reusable and should be cleaned periodically.
11. Install the Airaid Premium Filter (#1) to the Intake
Tube. Reconnect the Mass Air Flow and MAP sensors.
12. A) Attach the Weather Strip (#7) to the curved edge
of the Top Panel (#5). B) Attach the Top Panel to the
Airaid Performance Airbox using the four 1/4-20 Phil-
lips Head Screws. Reinstall the engine cover and the oil
fill cap.
13. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood
clearance
.
10. Attach the 1/2” Breather Hose to the Intake Tube
nipple and the factory valve cover fitting. Secure using
the Speed Clamps (#17).
A
Speed Clamps
Sensors
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
FILTER IDENTIFICATION
700-450 Airaid Oiled Media 701-450 Airaid SynthaMax Dry Media - Red
702-450 Airaid SynthaMax Dry Media - Black 703-450 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.