Extron electronic MKP 2000 - Manual (Page 17)

MKP 2000 Remote Control Panel • Local Operation MKP 2000 Remote Control Panel • Local Operation
Local Operation, cont’d
1 9 2 1 6 8 . 2 5 4 2 5 3 . .
2 5 5 2 5 5 . 0 0 0 0 0 0 . .
0 0 0 0 0 0 . 0 0 0 0 0 0 . .
0 0 0 0 0 0 .
.
.
.
.
.
.
.
.
.
.
.
. 0 0 0 0 0 0 . .
SEC Pri
INPUT OUTPUT
TAKE
OUTPUT
OUTPUT
OUTPUT
OUTPUT
OUTPUT
OUTPUT
INPUT
INPUT
INPUT
INPUT
INPUT
OUTPUT
OUTPUT OUTPUT
OUTPUT OUTPUT OUTPUT
INPUT
Sim u ltaneo u sly press and hold
the bu ttons for 2 seconds.
Release the bu ttons. The LED display sho w s the
most-significant octet of the
MKP 2000’s IP address.
Press the O u tp u t bu tton to cycle thro u gh
the displayed and edita b le octets.
Press the Inp
u
t
bu
tton to cycle thro
u
gh the displa
y
ed and
edita
b
le addresses and to reach the MKP set-
u
p settings
.
Most-significant Octet
(no dot)
Connected to
S w itcher
Control Tho u gh
Primary (RS-232)
Least-significant Octet
(dot in right-most position)
OP
n
PAS
OUTPUT OUTPUT
No
Pass-thro u gh
Port
Pass-thro u gh
MKP 2000’s
IP Address
MKP 2000’s
S ub net Mask
MKP 2000’s
Gate w ay
Address
Matrix
S w itcher’s
IP Address
Connection
Priority
Host Control
Setting
Figure 3-2 — Selecting octet fields and host control
3-6 3-7
2 . Use the Input button and Output button to select and
display the desired address and octet.
3 . Press the Cancel button to clear the octet to 000.
4 . Use the 0 through 9 buttons to enter the desired value for
the octet.
5 . Repeat steps 2 through 4 to select and change other
addresses and/or octets.
6 . Use the Input button to select the host control setting
display.
7 . If necessary, use the Output button to toggle the setting
between pass-through and no pass-through.
8 . Use the Input button to select the connection priority
display.
9 . If necessary, use the Output button to toggle the setting
between primary and secondary.
10 . When all addresses and octets and the host control and
priority settings are correct, press the Take button.
Host control port setting and pass-through communications
When the MKP is:
• Connected to a computer or control system via its Host
RS-232 port and
• Is in pass-through mode,
The MKP redirects valid matrix switcher SIS commands that it
receives on its Host RS-232 port to its Switcher RS-232 port.
When the MKP is:
• Connected to a computer or control system via its Host
RS-232 port and
• Is in no pass-through mode,
The MKP acts on all valid MKP commands received. It does not
pass the command to its Switcher RS-232 port.
When the MKP is:
• Selected as primary, it directly controls the matrix
switcher via its Switch RS-232 port or LAN port
• Selected as secondary,
The MKP controls the matrix switcher through connection to the
primary MKP’s IP address