Airaid 450-204 User Manual
Page 2
14. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
15. Reconnect the negative battery
cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.24.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
10. Install the hump hose (#5) onto the factory MAF
housing using two #60 hose clamps (#15) as shown.
Tighten only the clamp on the housing at this time.
11. On 1999-01 Models, Carefully install the factory
intake temp sensor into the grommet in the Airaid
Intake Tube.
12. Install the Airaid Intake Tube into the hump
hose first, and then onto the throttlebody. Adjust for
fit, and then tighten the two remaining hose clamps.
Reconnect the crankcase breather hose to the 5/8”x
3” hose, and connect the idle bypass hose to the
3/4” barbed fitting. Now reinstall the MAF sensor
onto the MAF housing using the factory screws.
13. Install the supplied weather strip (#7) onto the top
of the CAD starting at the fender and working your
way towards the radiator.
First
Second
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
FILTER IDENTIFICATION
700-462 Airaid Oiled Media 701-462 Airaid SynthaMax Dry Media - Red
702-462 Airaid SynthaMax Dry Media - Black 703-462 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.