Filter identification – Airaid 450-304 User Manual
Page 2
19. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
20. Reconnect the negative battery
cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.12.9.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Install the oval coupler (#3) with two #72
hose clamps (#12). Tighten only the clamp
closest to the aluminum fitting. (Hint: For a
clean look, locate the hose clamp tightening
screws under the tube)!
14. A.) Install the tube into the hump hose.
B.) Now slide the oval coupler onto the
throttle body. Tighten the remaining two
hose clamps, and re-connect the mass air
sensor, from step #2.
A.
B.
15. Install the Airaid Premium Filter (#1) onto
the filter adapter, and tighten the clamp. Install
the weather strip (#8) on the top of the CAD as
shown.
16. VERY CAREFULLY ! Using a razor
blade, cut the plastic tube off both of the factory
breather hose ends as shown.
17. Install the 3/8”x12” hose (#7) onto the
factory breather ends as shown.
18. Re-connect the breather line (#7) back to
the factory locations as shown.
22. Installation of this “RACE ONLY” intake system must be accompanied with a custom tune for prop-
er Mass Air Sensor functionality and drive-ability. Failure to install custom tune may result in poor per-
formance and severe engine damage
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
700-466 Airaid Oiled Media 701-466 Airaid SynthaMax Dry Media - Red
702-466 Airaid SynthaMax Dry Media - Black 703-466 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.