Airaid 300-637 - Manual (Page 2)

The sound of power...The “whistle”
means its working!
5. Insert the PowerAid spacer into the intake manifold. The
gasket will go between the PowerAid and the throttlebody.
3. Loosen the clamps on both ends of the intake tube, and re-
move from the engine compartment. 4. Remove the four bolts that secure the throttlebody to the in-
take manifold. Without disconnecting the wiring harness, re-
move the throttlebody from the intake manifold and set it to the
side.
Alignment Pin
O-ring
5. Reinstall the throttlebody on top of the Poweraid Spacer us-
ing the four bolts and washers that are supplied with the kit.
Tighten the bolts evenly to the vehicle manufacturers specifica-
tions, in a “X” pattern.
Contact your nearest Airaid dealer for
an Airaid Intake System for your car,
truck or SUV.
5. Reinstall the intake tube and engine cover in the reverse order
that they were removed. Make sure to reconnect the temperature
sensor.
Re-connect the negative battery cable!
Gasket
Rev:01.13.15
1
4 2
3
Spacer