Airaid 310-510 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from throttle body (Ref. “A”).
4. Remove gasket and clean surfaces.
5. Install Power plate with (2) gaskets (Ref. “B”).
a. One gasket located between throttle body and power plate.
b. One gasket located between power plate and manifold.
6. Replace (4) bolts (Ref. “A”) using (Step # 3) as an example.
7. Locate and install (3) spacers under linkage bracket (Ref. “C”) using (3) 6mm x 40mm bolts.
8. Inspect & Test throttle linkage for full open & closed travel before driving.
Some cruise or kick down cables may require adjustment. Refer to service manual.
9. Reinstall throttle body air intake assembly using (Step # 3) as an example.
10. Double check your work. Reconnect the battery cable. ENJOY!!
The sound of power...The “whistle” means its working!
Ref. C- (3) Spacers 1”
(3) 6mm x 40mm Bolts
Ref. A- (4) Bolts 6mm x 50mm
(4) Washers 6mm
Ref. B– Poweraid Plate
(2) Gaskets
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Rev. 12/22/06