Eaton Electrical Powerware BladeUPS Bar - Manual (Page 17)

INSTALLATION
EATON Powerware ® BladeUPS ® Bar Installation Guide S 164201723 Rev P01 13
17. Using two M6 ×12 hex bolts, secure the left side of the wireway
terminal block housing to the rack. See Figure 8. Torque the bolts to
5.1 ± 0.8 Nm (45 ± 7 lb in).
18. Using nine M4 ×8 pan-head screws, secure the wireway terminal
block housing to the wireway and to the bar. See Figure 8. Torque
the screws to 1.7 ± 0.2 Nm (15 ± 2 lb in).
M6 × 12 Hex Bolts
(2 places)
M4 × 8 Pan-Head Screws
(9 places)
Wireway
Terminal Block
Housing
Figure 8. Wireway Terminal Block Housing Installation