Airaid 883-316 User Manual
Page 2
12. Install the Hump Hose (#7) and Aluminum Intake
Tube (#2) onto the Fender adapter. Loosely install two
#48 Clamps (#10) onto the Hump Hose.
13. Install the Silicone Elbow (#6) and two #48 clamps
onto the Inlet as shown. Leave the Hose Clamps loose
for now.
10. Insert the Foam Pre-Filter (#5) into the Snorkel Inlet
(#3) .
REV.02.12.14
14. Install the Snorkel Inlet and elbow onto the Intake
tube. Align the assembly into the desired position and
tighten all of the Clamps.
9. Reinstall the fender onto the vehicle, reusing the
nine fasteners from step 2.
15. Secure the snorkel assembly to the roll cage using
the Tube Mounts (#8) and #68 Clamps (#11).
16. Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and
screws are tight.
Make sure all clamps, hoses, bolts, and screws are
tight. Periodically check the tightness
of all hose
clamps.
Reconnect the negative battery cable and reinstall
the seat.
11. Install the Snorkel Screen (#4) onto the Inlet using
four 8-32 Button Head Screws (# 12) and a 5/32” Allen
wrench.
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Driver side left kit 883-316 shown
Component Identification
1.
Fender Adapter
1
2.
3.00” x 8.00” Aluminum Tube
1
3.
Snorkel Inlet
1
4.
Snorkel Screen
1
5.
Foam Pre-filter
1
6.
3.00” 25° Silicone Elbow
1
7.
Silicone Hump Hose
1
8.
Urethane Tube Mount
2
9.
Foam Gasket Tape, 24”
1
10.
#48 Hose Clamp
4
11.
#68 Hose Clamp
2
12.
8-32 x ½” Button Head Screw
4
13.
¼”-20 x ½” Button Head Screw
4