Airlink AML001 - Manual (Page 55)

PCI Modem Card User's Manual
54
+GOI—Request Global Object Identification
This command returns the ISO registration object identifier.
+GOI Displays the ISO registration object identifier followed
by the OK result code.
+GOI=?, +GOI? Displays the ISO registration object identifier followed
by the ERROR result code.
+GSN—Request Product Serial Number Identification
This command returns the product serial number.
+IDSR=<value>—Select Data Set Ready Option
Use this command to select how the soft modem manages the DSR signal
(V.24 circuit 107).
+IDSR=0 DSR is always on.
+IDSR=1 DSR functions as defined in ITU-T recommendation V.24.
+IFC=<DCE_by_DTE>, <DTE_by_DCE>—DTE-DCE Local Flow
Control
Use this command to select the local flow control method. The input
parameters of the +IFC command overwrite the settings of the \Q and
\X<value> commands. The reverse is also true. By modifying the settings of
the \Q and \X<value> commands, the +IFC command parameters are
overwritten.
+IFC=0,0 No flow control.
+IFC=1,1 Software flow control.
+IFC=2,2 Hardware flow control (default).
+IFC=3,1 Software flow control with XON/OFF characters passed on to
the remote DCE.
+ILRR=<value>—DTE-DCE Local Rate Reporting
Use this command to display or hide the local rate report result code. If the
rate report is enabled, the reported <rate> is the current DTE-DCE rate. The
rate report is an intermediate result code. It is transmitted after any
modulation, error control, or data compression reports, and before the final
result code (e.g., CONNECT).
+ILRR=0 Disables the local rate report (default).
+ILRR=1 Enables the local rate report.