All Power APG3590CN - Manual (Page 23)

Powering 120/240 Volt AC Tools And Equipment:
Operation (cont’d)
Owner’s Manual
1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage
capacity (120V/240 AC @ 50/25 AMPs) is adequate to supply all electrical loads that the unit will
power. If powering exceeds the generator’s capacity, it may be necessary to group one or more
of the tools and/or equipment for connection to a separate generator.
CAUTION: ATTEMPTING TO POWER SENSITIVE ELECTRONIC EQUIPMENT
WITHOUT THE USE OF AN APPROVED LINE CONDITIONER MAY CAUSE
DAMAGE TO THE EQUIPMENT. ALL-POWER AMERICA IS NOT RESPONSIBLE
FOR ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE TO USE AN
APPROVED LINE CONDITIONER.
2. Once the generator is running, simply connect the power cords of 120/240 volt AC powered
tools and equipment into the 120/240 volt AC dual outlets.
3. Disconnect all electrical powered tools and equipment from the generator’s 120/240 volt AC
duel outlets.
4. After the engine and generator have completely cooled, store generator in a safe, clean, dry
23
location (if not already installed).
NOTE: THE GENERATOR FEATURES AN AC NON-FUSE CIRCUIT BREAKER TO
PROTECT THE AC CIRCUIT IN CASE OF AN OVERLOAD. SHOULD AN
OVERLOAD OCCUR, THE BREAKER WILL “TRIP” TO ITS “OFF” POSITION.