Allmand Brothers NIGHT LITE PRO V - Manual (Page 43)

43
6/9/2011
OPERATION
Raising and Lowering the Light
Tower
Light Tower
Note: The Hydraulic actuated light tower
uses 12VDC battery power to operate. The
light tower may be raised and lowered as
needed without the engine running.
Figure 18
1. Seven Section Light Tower
Raising
NOTICE: Before raising light tower, visu-
ally inspect equipment for damage or wear
and repair or replace components as re-
quired. Never operate the light tower with
damaged or malfunctioning components.
1
1. Before raising the light tower, adjust the tower
lights to the desired work position; see Light
Bar and Light Fixture Adjustment on page 42.
2. If required, start engine. Refer to your Engine
Operator’s Manual for starting procedure.
3. Turn the lights off; see Light Control Panel on
page 44.
4. Press the light tower hydraulic lift switch up to
raise the light tower to the desired height.
Figure 19
1. Light Tower Hydraulic Lift Switch.
Lowering
1. If required, start engine. Refer to your Engine
Operator’s Manual for starting procedure.
2. Turn the lights off; see Light Control Panel on
page 44.
3. Press the tower light hydraulic lift Switch down
to lower the light tower to the desired height or
to the full DOWN position.
4. When tower reaches the bottom, run switch
for 3 additional seconds to ensure that the
tower is at its lowest possible position.
5. Stop engine.
1