ARAG BRAVO 300S - Multi-row crop sprayers, Direct connection / RCU Installation - Software ver - Manual (Page 17)

17
RCU HARNESS
Item Main connection Alternative connection
f Flowmeter -
g Main valve -
l Level sensor -
M Pressure sensor -
p Control valve -
r Foam marker -
s Speed sensor -
t Filling flowmeter Pump Protector
X RPM sensor Pump Protector
Tab. 5
CAUTION:
The secondary connection "T" shall be used only if connection "X" is already occu-
pied by another sensor.
Do not use the secondary input "T" if no sensor is connected to the "X" input, other-
wise the computer will not be able to acknowledge the Pump Protector sensor.
The products are supplied with the sensor installation instructions.
The following speed sensors can also be used as RPM sensors:
• inductive speed sensor
(code 467100.086);
• magnetic speed sensor (code 467100.100).
- Connection of:
• flowmeter;
• pressure sensor;
• level sensor;
• Pump Protector;
• filling flowmeter;
• RPM sensor;
• foam marker.
All ARAG sensors use the same type of connector. Connect the sensor connector to the relevant
harness; make sure it is correctly fitted and push it until locking it.
Fig. 14a Fig. 14b